Wow. It’s been a while since I set this up.
Unfortunately, I don’t think I ever “extracted” the codes sent by the remote. For most of what I cared about: that being fan speed, once it had “recognized” the remote via the lights on/off command, all four commands for fan speed were built into the Bond Bridge. Setting the speed to slow, medium and fast, or turning the fan off.
I then had it “learn” the toggle direction command simply by putting the Bond Bridge in “learn” mode, and issuing the reverse command on the remote. After a few attempts at that, the Bond Bridge has been able to repeat that command, thus I have everything I need.
So this means I don’t think I ever saw the exact commands that are being sent to the fan.
However, if there’s some way that it’s possible to use the http:// API to extract the codes of the various commands I’m sending, then I can do that and post them here. We just need to find a real expert on the Bond Bridge (I’m not an expert by any means. 
) who might be able to help doing this.
Even assuming it’s possible.
The other thing to note is that this can only work if you’re using a Kichler Fan that works with the remote I mentioned further up the thread. That’s the one I have in use here, and it’s the only remote I’d have codes for. Copying from an earlier post of mine:
“371045MUL wall mount or the 371085 family of hand held remotes. 65K full function as described by Kichler.”
That said, this thread seems to indicate there may be a backup and restore capability that might be used to copy what I have to your bond bridge. Assuming your fan uses the same remote.
Duplicate configuration from one bridge to another? - BOND Setup and Hardware - Bond Home Forum