# Skytech 3001 K9L3001TX **URL:** https://forum.bondhome.io/t/skytech-3001-k9l3001tx/144 **Category:** Fireplaces **Created:** [March 13, 2018, 12:11am UTC](https://forum.bondhome.io/t/skytech-3001-k9l3001tx/144 "2018-03-13T00:11:03Z") **Posts on this page:** 1 **Showing post:** 15
### Author: ![RobJohansen](https://avatars.discourse-cdn.com/v4/letter/r/ee7513/32.png) [@RobJohansen](https://forum.bondhome.io/u/RobJohansen) #### Post date: [September 15, 2021, 1:22am UTC](https://forum.bondhome.io/t/skytech-3001-k9l3001tx/144/15 "2021-09-15T01:22:23Z")
I also have a remote with an FCC ID of K93001 TX. Mine is with a Heat-n-Glo fireplace. I had the same problem where if I did the auto-program, it detected RFP10 and would work fine in the test mode, but would not work once set. Once I did have it working, I found out about the “keep alive”. These threads helped me: > [@Proflame 2 Fireplace Remote](https://forum.bondhome.io/t/proflame-2-fireplace-remote/2156/4): > > Any luck with this? I have a client with a couple of these and I was hoping to be able to use Bond to integrate them. > [@Fireplace turning off after a few minutes (American Flame)](https://forum.bondhome.io/t/fireplace-turning-off-after-a-few-minutes-american-flame/1219): > > Hello, Hoping someone can help here. I have an American Flame remote 4000HHS02. It appears that the remote and fireplace communicate every 10 minutes or so, and that overwrites whatever status it was in from the Bond. For instance, this remote has three “states:”. OFF/ON/THERMO. When Bond turns on the fire etc, the remote doesn’t change. So if the remote is in off, and i use Bond to turn the fire on, after a short time it turns back off. Anyone have any experience with this and have a wor… How I got this to work was to manually program each button. The key to programming it was to use the remote to put the fireplace in the mode prior to the mode that I wanted to program, so that when the BOND was learning, when I pressed the remote button, it would be going to that state. So, to program “Off”, the fireplace had to be in the “On Thermo” state. To program 'On" , the fireplace could be in the “Off” state. For the fan speed, which goes: Off-\>High-\>Medium-\>Low-\>Off, To program “High”, have it in “Off”, so that it is changing to “High” when clicking the ‘Fan’ button For “Medium”, have it on “High” etc… Then, I tested what I found in the other thread about the remote’s keep-alive. Sure enough, the fireplace would revert to the remote’s state when the remote’s clock hit 00/15/30/45 minutes. For that, it seems the solution is to remove the remote batteries. I’ve only had this fixed tonight, and have not done extensive testing or use yet. But so far, so good. --- _[View the full topic](https://forum.bondhome.io/t/skytech-3001-k9l3001tx/144)._